×

Click for
Table of Contents

menuUAP-IW Quick Start Guide

Package Contents

UAP-IW
Cover Plate
Rubber Feet

Installation Requirements

IMPORTANT: UniFi Controller v5.x is recommended for managing the UAP-IW and is available for download at: ui.com/download/unifi

IMPORTANT: The UAP-IW requires a UniFi Switch with PoE for power. Passive PoE adapters are not recommended.

System Requirements

Hardware Overview

LED

Reset Button

The Reset button serves two functions for the UniFi AP:

  • Restart Press and release the Reset button quickly.
  • Restore to Factory Default Settings Press and hold the Reset button for more than five seconds.

PoE Out + Data Port

10/100 Ethernet port supports data and PoE. Used to connect an 802.3af device to the LAN.

Data Port

10/100 Ethernet port supports data only. Used to connect a client device to the LAN.

PoE In + Data Port

10/100 Ethernet port supports data and PoE. Connect this port to a UniFi PoE Switch that is connected to your LAN and DHCP server.

Hardware Installation

An electrical wall box should be pre-installed with an Ethernet cable running from the box to a UniFi Switch with PoE.

  1.  
  2. Note: If the wall box does not have enough room to accommodate the UAP-IW without straining the Ethernet connection, replace the wall box with an open-end or deeper box.

  3.  
  4. Note: Adjust the screws to ensure the mounting plate is flush with the wall for proper fitting of the Cover Plate. Do not over-tighten or rely on the force of the screws to pull the UAP-IW into the wall box.

    Optional

    If needed, use the optional Rubber Feet to fill in some of the space between the UAP-IW and the threaded mount holes of the wall box.

  5. Note: If you are using your own cover plate, secure it with two screws.

Specifications

UAP-IW

Dimensions

114.6 x 70.6 x 28.5 mm

(4.51 x 2.78 x 1.12")

Weight

117 g (4.127 oz)

Networking Interface

(3) 10/100 Ethernet Ports

Button(s)

Reset

Power Method

UniFi Switch (PoE)

Power Save

Supported

PoE Out

48V Pass-Through (Pins 1, 2+; 3, 6-)

Max. Power Consumption

6W

Max. TX Power

17 dBm

Antenna Gain

1 dBi

Wi-Fi Standards

802.11 b/g/n

Wireless Security

WEP, WPA-PSK, WPA-Enterprise
(WPA/WPA2, TKIP/AES)

Mounting

1-Gang Electrical Wall Box (Not Included)

Operating Band

2.4 GHz

VLAN

802.1Q

Advanced QOS

Per-User Rate Limiting

Guest Traffic Isolation

Supported

Concurrent Clients

100+

Operating Temperature

-10 to 70° C (14 to 158° F)

Operating Humidity

5 to 95% Noncondensing

Certifications

CE, FCC, IC