×

Click for
Table of Contents

menuU-Installer Quick Start Guide

Package Contents

U‑Installer
Carabiner

Hardware Overview

Carabiner

Accessory for attaching the U-Installer to a belt (use is optional). To use, insert into the Clip Loop and attach to a belt loop or utility belt.

Clip Loop

Used to attach the Carabiner.

Wi-Fi LED

Lights blue if the U-Installer has a Wi-Fi connection to your mobile device.

Battery LED

Four blue LEDs indicate the internal battery’s charge level:

Reset Ext Button

To reset the device connected to the U-Installer to factory defaults, press this button while the device is powered on. Hold the button for more than eight seconds until the LEDs on the device flash.

Power Button

Press to power the U-Installer on or off. The Battery LEDs light when power is on.

Reset Button

To reset the U-Installer to factory defaults, press and hold the Reset button while the U-Installer is powered on until the LEDs on the device flash.

USB-C Port

When there is a low charge, recharge the internal battery by connecting a power source, such as a mobile battery pack, to the USB Type C port.

PoE OUT Port

Supplies 24V passive PoE to the device being installed.

Configuring a CPE Device

Use a mobile device (default method) or a laptop to configure the CPE device at the point of installation via the U-Installer’s Wi-Fi:

You have two options for configuration: the UNMS App and Web Portal.

UNMS App - Default Method

  1. iOS devices only: Connect your mobile device’s Wi-Fi to the U-Installer SSID named: ubi:<MAC Address>
  2. Download and launch the UNMS app on your mobile device.

  3. Connect to the CPE device:
  4. iOS

    1. On the Connections screen, tap the CPE device.
    2. Tap Log in to automatically log into the device.

    Android

    1. Tap , and then tap Installer.
    2. The app will automatically detect and connect to the U-Installer SSID named: ubi:<MAC_Address>
    3. On the Discover screen, tap the CPE device to automatically log into the device.
  5. Follow the on-screen instructions.

Web Portal

  1. Connect your device’s Wi-Fi to the U-Installer SSID named: ubi:<MAC_Address>
  2. Open a web browser and go to: https://192.168.1.20
  3. Select your Country and Language. You must agree to the Terms of Use to use the product. Click Continue.

  4. Create a username and password. Confirm your new password and then click Save.
  5. Configure the CPE device as needed.

Removing the U-Installer

After you have configured the CPE device, remove the U-Installer:

  1.  

OR

Specifications

U-Installer

Wi-Fi Frequency

2.4 GHz

Max Transmit Power

22 dBm

Max Power Consumption

U-Installer 3W
U-Installer with CPE 15W