EdgeOS Firmware Changelog
====
Supported products
  * EdgePoint R6, model: EP-R6
  * EdgePoint R8, model: EP-R8
  * EdgeRouter X, model: ER-X
  * EdgeRouter X SFP, model: ER-X-SFP
  * EdgeRouter Lite, model: ERLite-3
  * EdgeRouter PoE, model: ERPoe-5
  * EdgeRouter, model: ER-8
  * EdgeRouter PRO, model: ERPro-8
  * EdgeRouter 4, model: ER-4
  * EdgeRouter 6P, model: ER-6P
  * EdgeRouter 12, model: ER-12
  * EdgeRouter 12P, model: ER-12P
  * EdgeRouter Infinity, model: ER-8-XG
====

2.0.3 (e50, e100, e200, e300, e1000) Changelog / May 31, 2019
====
Fixes:
Offloading - Fix regression in v2.0.1 that caused random reboots of ER-X/ER-X-SFP and EP-R6 routers 
             when hwnat offloading was enabled.
Offloading - Fix regression in v2.0.1 that caused random filesystem corruption and failure to boot 
             of ER-X/ER-X-SFP and EP-R6 routers when hwnat offloading was enabled
WebGUI - Fix regression in v2.0.0 when ping in WebGUI did not work
WebGUI - Fix bad eth9 interface in Basic Setup Wizard on ER-X and ER-4
WebGUI - Add checkbox to toggle IPv6 functionality from WebGUI
WebGUI - Fix bug that caused WebGUI/UNMS to become inactive if aggressive network scanners opens 
         lots of unauthorized sessions
UNMS - Allow acquiring extended device info/stats from UNMS
UNMS - Add URL redirect functionality for suspended users
UNMS - Fix optimized QoS configuration via UNMS
QoS - Fix bug in v2.0.1 that caused Qdisc to be configured on all ER-X interfaces.
Firewall - Fix bad firewall rules when MSS clamping is configured.
Firewall - Fix regression in v2.0.0 that caused firewall section to disappear if rule had TCP_UDP 
           protocol assigned to HTTP port
IPv6 - Add CLI commands to configure IPv6 PBR.
FlowAccounting - Fix netflow daemon crash if WAN interface is down for more than 1 minute.
Interface - Fix bug when rx/tx counters of switch-port interfaces were not updated on 
            ER-X/ER-S-SFP models
Interface - Fix regression in v2.0.0 when IPv6 statically configured addresses were missing 
            after boot
OpenVPN - Fix regression in v2.0.0 when client-specific options were ignored
Bonding - Fix bug when bonding did not pass traffic if switch-port interfaces are used on ER-12
QOS - Now transit packets will bypass offloading if netflow or qos or suspend is configured
IPv6 - Fix IPv6 bug when address auto-configuration for VLAN interfaces did not work when enabled.
IPV6 - Fix regression in v2.0.0 when radvd did not work correctly when multiple router-advert 
       were configured
MDNS - Fix bug when mdns service did not start if VTI interface was configured
DHCP - Fix bug when 0.0.0.0/0 static route sometimes was not restored when nexthot address 
       became reachable
CLI - Fix Perl error message when running "clear dhcp lease ip ..." CLI command
TechSupport - Fix bug when tech-support file was truncated if flow-accounting was configured
TechSupport - Add output of journalctl to tech-support file
TechSupport - Add runtime state of flow-accounting to tech-support file